Toyota Corolla (E170): Correct use of the seat belts

Make sure that all occupants are wearing their seat belts before driving the vehicle. Use a child restraint system appropriate for the child until the child becomes large enough to properly wear the vehicle’s seat belt.

    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect skid control ecu connector(+bs terminal voltage) Disconnect the skid control ecu connector.  measure the voltage between terminals +bs (2) and gnd (1, 23) of skid control ecu harness side connector. Voltage: 10 – 14 v 2 Reconfirm dtc Check the dtc . Ok : ...

    Changing the passkey
    1 Select “Passkey” using . 2 Input a 4 to 8-digit passkey using . Input the number 1 digit at a time. 3 When the entire number to be registered as a passkey has been input, press again. If the passkey to be registered has 8 digits, pressing again is not necessary. ...

    Removal & installation and disassembly & re
    1. Remove bench type rear seat cushion assy (, 72–8) 2. Remove rear floor service hole cover 3. Work for preventing gasoline from spilling out  start the engine.  after the engine has stopped on the its own, turn the ignition switch to lock. 4. Disconnect fuel tank main tu ...