Toyota Corolla (E170): Changing the passkey

1 Select “Passkey” using a 4 to 8-digit passkey using .. 2 Input a 4 to 8-digit passkey using Input the number 1 digit at a time..

Input the number 1 digit at a time.

3 When the entire number to be registered as a passkey has been input, press If the passkey to be registered has 8 digits, pressing again.

If the passkey to be registered has 8 digits, pressing Setting automatic connection of the device on or off again is not necessary.

    Share this page:

    Other materials:

    Oxygen / af sensor heater monitor
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

    Refueling
    Opening the fuel tank cap Perform the following steps to open the fuel tank cap: Before refueling the vehicle Turn the engine switch off and ensure that all the doors and windows are closed. Confirm the type of fuel. ■Fuel tank opening for unleaded gasoline To help prevent incorrect fueling, ...

    Adding engine oil
    ■ Checking the oil type and preparing the item needed Make sure to check the oil type and prepare the items needed before adding oil. Engine oil selection Oil quantity (Low level mark Refill upper limit mark) 1.6 qt. (1.5 L, 1.3 Imp. qt.) Item Clean funnel ■ Adding engine oil If the oil ...