Toyota Corolla (E170): For safety and security

Share this page:

Other materials:

Terminals of ecu
1. Inspect integration relay Disconnect the connector from the integration relay. check the continuity between each terminal of the disconnected connector and the body ground, as shown in the illustration and table. Standard: If the result is not as specified, the vehicle’s ...

Problem symptoms table
Hint: proceed with troubleshooting of each circuit in the table below. Symptom Suspect area When the ignition switch is in the on position, the srs warning light sometimes comes on after approximately 6 seconds.  Srs warning light ci ...

Inspection procedure
1 Check p squib circuit(airbag sensor assy center – instrument panel passenger airbag assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connector between the airbag sensor assy center and the instrument panel ...