Toyota Corolla (E120): Short in side squib (rh) circuit (to b+)

Dtc b0113/42 short in side squib (rh) circuit (to b+)

Share this page:

Other materials:

Inspection procedure
Hint: if different dtcs related to different systems that have terminal e2 as the ground terminal are output simultaneously, terminal e2 may be open. Read freeze frame data using the hand-held tester or the obd ii scan tool. Freeze frame data records the engine conditions when a malf ...

Turning on light switch does not light up night time illumination of radio receiver
Wiring diagram Inspection procedure 1 Inspect radio receiver assy(ill+, ill–) Check that the voltage between terminals at each condition, as shown in the chart. Standard: Repair or replace harness or connector ...

Front suspension arm sub–assy lower no.1 Lh
Replacement Hint: components: 1. Remove front wheel 2. Disconnect front stabilizer link assy lh (lh (a/t) position) 3. Disconnect front stabilizer link assy rh (lh (a/t) position) Hint: remove the rh side by the same procedures as the lh side. 4. Separate front suspension arm sub–assy lowe ...