Toyota Corolla (E120): Rear suspension

Preparation

Sst

Recomended tools

Recomended tools

Equipment

Equipment

Tire & wheel

Tire & wheel

Preparation

Equipment

Drive shaft / propeller shaft

    Share this page:

    Other materials:

    Inspection procedure
    Hint: this dtc chart is on the premise that the engine is cranked normally. If the engine is not cranked, proceed to the problem symptoms table on page 05–42. Read freeze frame data using the hand-held tester or the obd ii scan tool. Freeze frame data records the engine conditions ...

    Inspection
    1. Intake air flow meter sub–assy Inspect the intake air flow meter resistance.  Using an ohmmeter, measure the resistance between terminals tha and e2. Resistance: at –20 c (–4 f) 13.6 To 18.4 KΩ at 20 c (68 f) 2.21 To 2.69 KΩ at 60 c (140 f) 0.49 To 0.67 ...

    Pre–check
    1. Selecting compass display mode  the compass switch allows you to select the display or non–display mode of the compass. 2. Setting zone  deviation between the ”magnetic north” and ”actual north” differs depending on the location. Therefore, adjustment of the ...