Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Supplemental restraint system / Terminals of ecu
Toyota Corolla (E120): Terminals of ecu
Other materials:
On–vehicle inspection
1. Inspect refrigerant pressure with manifold gauge set
this is a method in witch the trouble is located by using
a manifold gauge set. Read the manifold gauge pressure
when the these conditions are established.
Test conditions:
temperature at the air inlet with the switch set
...
Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal)
Turn the ignition switch to on.
measure voltage between terminals ts and cg of dlc3.
Ok:
voltage: 10 – 14 v
2 Check harness and connector(dlc3 – body ground)
Check for open and short circuit in harness and connector between
...
Removal & installation and disassembly & reassembly
1. Remove bench type rear seat cushion assy
2. Remove rear floor service hole cover
Remove the rear service hole cover.
Disconnect the fuel pump and vapor pressure sensor
connector.
3. Work for preventing gasoline from spilling out
Start the engine.
after the engi ...