Toyota Corolla (E120): Problem symptoms table

Hint

: proceed with troubleshooting of each circuit in the table below.

Symptom

Suspect area

  • When the ignition switch is in the on position, the srs warning light sometimes comes on after approximately 6 seconds.
  •  Srs warning light circuit malfunction (Always lights up, when dtc is not output).
  • Srs warning light always comes on even when dtc is not output.
  • With the ignition switch is in the on position, the srs warning light does not come on.
  • Srs warning light circuit malfunction (does not light up, when ignition switch is turned to on).
  • Although a srs warning light operates normally, dtc or a normal system code is not displayed.
  • Tc terminal circuit
  • Although the terminals tc and cg are not connected, dtc or a normal system code are displayed
    Share this page:

    Other materials:

    Overhaul
    1. Remove w/head taper screw plug no.2 Using a socket hexagon wench 10, remove the taper screw plug and gasket. 2. Remove valve lifter Remove the valve lifters from the cylinder head. 3. Remove valve Place the cylinder head on wooden blocks.  using sst, compres ...

    Inspection procedure
    1 Inspect shift solenoid valve(sl) Remove the shift solenoid valve sl.  measure the resistance according to the value(s) in the table below. Standard: Connect the positive (+) battery lead to the solenoid connector terminal, and the negative (–) battery lead to the so ...

    Positioning a floor jack
    When using a floor jack, follow the instructions in the manual provided with the jack and perform the operation safely. When raising your vehicle with a floor jack, position the jack correctly. Improper placement may damage your vehicle or cause injury. Location of the jack point ■ Front ■ Rea ...