Toyota Corolla (E120): Sliding roof system

Share this page:

Other materials:

Skid control sensor
Replacement Hint: replace the rh side by the same procedure as the lh side. 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Disconnect skid control sensor wire Disconnect the skid control sensor wire connector from the skid control sensor. 4. Remove rear axle hub & ...

Body rocker panel moulding lh
Replacement Hint: use the same procedures for the rh side and lh side. 1. Remove body rocker panel moulding lh Remove the 8 retainers.  using a screwdriver, remove the moulding. Hint: tape the screwdriver tip before use.  remove the 7 clips from the moulding. 2. Insta ...

Hood
Opening the hood 1. Pull the hood lock release lever. The hood will pop up slightly. 2. Pull the auxiliary catch lever to the left and lift the hood. 3. Hold the hood open by inserting the support rod into the slot. WARNING ■Pre-driving check Check that the hood is fully closed and locked. If ...