Toyota Corolla (E120): Sliding roof/convertible

Share this page:

Other materials:

Inspection procedure
1 Check wire harness(dlc3 – airbag sensor assy center) Turn the ignition switch to the lock position.  disconnect the aribag sensor assy center connector.  measure the resistance according to the value(s) in the table below. Standard: 2 Check wire harness(cg of dl ...

Inside rear view mirror
The rear view mirror's position can be adjusted to enable sufficient confirmation of the rear view. Adjusting the height of rear view mirror The height of the rear view mirror can be adjusted to suit your driving posture. Adjust the height of the rear view mirror by moving it up and down. WARNING ...

On–vehicle inspection
1. Inspect speedometer  check the operation. Using a speedometer tester, inspect the speedometer fro allowable indication error and check the operation of the odometer. Reference: Notice: tire wear and tire over or under inflation will increase the indication error. ...