Toyota Corolla (E120): Sliding roof

Share this page:

Other materials:

Oxygen / af sensor heater monitor
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

Replacement
1. Remove hood sub–assy 2. Remove cylinder head cover no.2 3. Remove battery 4. Remove battery carrier Remove the 4 bolts and battery carrier. 5. Remove air cleaner assembly with hose 6. Remove floor shift cable transmission control shift Remove the nut from the control shaf ...

Checking and adding the brake fluid
■ Checking fluid level The brake fluid level should be between the "MAX" and "MIN" lines on the tank. ■ Adding fluid 1. Slide and lift up the rubber strip to partly remove it as shown. 2. Disconnect the claws and remove the service cover. 3. Remove the reservoir cap. 4. Add brake fluid slowl ...