Toyota Corolla (E120): Short in p squib circuit (to b+)

Dtc b0108/52 short in p squib circuit (to b+)

Share this page:

Other materials:

Inspection procedure
1 Check wire harness(airbag sensor assy center – front seat inner belt assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat inner belt assy ( ...

On–vehicle inspection
1. Inspect drive belt Visually check the belt for excessive wear, frayed cords, etc. If any defect is found, replace the drive belt. Hint: cracks on the rib side of a belt are considered acceptable. If the missing chunks from the ribs are found on the belt, it should be replaced. 2 ...

Air outlets
■ Location of air outlets The air outlets and air volume changes according to the selected airflow mode. : Some models ■ Adjusting the position of and opening and closing the air outlets ► Front center outlets Direct air flow to the left or right, up or down. ► Fro ...