Toyota Corolla (E120): Inspection procedure

1 Inspect terminal voltage(idl)

  1. Remove the cruise control ecu assy with connector still connected.
  2.  disconnect the ecm connector.
  3.  turn the ignition switch to on.
  4.  measure voltage between terminal 13 (idl) of cruise control ecu assy connector and body ground when the throttle valve is fully closed and fully opened.

    Ok:

2 Check harness and connector(between cruise control ecu assy

2 Check harness and connector(between cruise control ecu assy and ecm)

  1. Check for open and short circuit in harness and connector between cruise control ecu assy and ecm

Check and replace cruise control ecu assy

Check and replace cruise control ecu assy

    Share this page:

    Other materials:

    Pre–check
    1. Selecting compass display mode  the compass switch allows you to select the display or non–display mode of the compass. 2. Setting zone  deviation between the ”magnetic north” and ”actual north” differs depending on the location. Therefore, adjustment of the ...

    Location of the storage features
    Bottle holders/door pockets Open trays (if equipped) Glove box Cup holders (if equipped) Console box WARNING ■Items that should not be left in the storage spaces Do not leave glasses, spray cans in the storage spaces, as this may cause the following when cabin temperature becomes high: ...

    Inspection procedure
    1 Inspect dlc3 terminal voltage(ts terminal) Turn the ignition switch to on. measure voltage between terminals ts and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector between ...