Toyota Corolla (E170): Scanning folders

1 Press and hold beep. until you hear a beep.

The first 10 seconds of the first file in the each folder will be played.

2 When the desired folder is reached, press Selecting a file again.

    Share this page:

    Other materials:

    Oxygen sensor monitor (front and rear o2s system)
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...

    Eco drive mode (if equipped)
    Press the switch. Suitable for enhancing the fuel economy, because the torque corresponding to the accelerator pedal depression amount can be generated more smoothly than it is in normal conditions and the operation of the air conditioning system (heating/cooling) will be minimized. Press th ...

    Overhaul
    1. Remove roof headlining assy 2. Remove sliding roof glass sub–assy  using a torx wrench (t25), remove the 4 screws the sliding roof glass.  pull the glass upward to remove it. 3. Remove sliding roof weatherstrip 4. Remove sliding roof drive gear sub–assy Notice: ...