Toyota Corolla (E170): Selecting a file

Turn or or press to select the desired file. or Scanning files to select the desired file.

    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect dlc3 terminal voltage(tc terminal) Turn the ignition switch to on.  measure voltage between terminals tc and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector betw ...

    Pre–check
    1. Diagnosis system Release the parking brake lever.  check the warning lights. When the ignition switch is turned on, check that the abs warning light and brake warning light goes on for 3 sec. Hint: when the parking brake is applied or the level of the brake fluid is low, the ...

    Replacement
    1. Remove battery 2. Remove battery carrier Remove the 4 bolts and battery carrier. 3. Disconnect floor shift cable transmission control shift Remove the nut from the control shaft lever.  disconnect the control cable from the control shaft lever.  remove the clip a ...