Toyota Corolla (E120): Rear spoiler

Share this page:

Other materials:

Inspection procedure
Hint: start the inspection from step 1 in case of using the hand–held tester and start from step 2 in case of not using the hand–held tester. 1 Perform active test by hand–held tester(abs warning light) Check that ”on” and ”off” of the abs warning light can be shown on the ...

Evap monitor (vacuum pressure monitor)
Notice: a cold soak must be performed prior to conducting the drive pattern to complete the internal pressure readiness monitor. Cold soak preconditions The monitor will not run unless: mil is off. Fuel level is approximately 1/2 to 3/4. Altitude is 7800 feet (2400 m) or less. ...

On–vehicle inspection
1. Inspect wireless door lock control functions Hint: the switch described in this text is a switch for transmitting signals (lock switch, unlock switch and panic switch) which is built into the door control transmitter. All the functions listed below must be checked in the remote contro ...