Toyota Corolla (E120) 2002–2008 Repair Manual / Exterior/interior trim
Toyota Corolla (E120): Exterior/interior trim
- Front bumper
- Rear bumper
- Rear spoiler
- Out side moulding
- Front door belt moulding assy lh
- Rear door belt moulding assy lh
- Body rocker panel moulding lh
- Side mudguard sub–assy lh
- Luggage compartment door garnish outside
- Roof drip side finish moulding center lh
- Roof headlining assy
Other materials:
Circuit description
The p squib circuit consists of the airbag sensor assy center and instrument
panel passenger airbag assy.
It causes the srs to deploy when the srs deployment conditions are satisfied.
Dtc b0105/53 is recorded when a short is detected in the p squib circuit.
Wiring diagram
...
Oxygen sensor monitor (front and rear o2s system)
Preconditions
The monitor will not run unless:
mil is off
drive pattern
connect the obd ii scan tool to the dlc3 to check monitor status
and preconditions.
Start the engine and allow it to idle for 2 minutes or more.
Drive the vehicle at 25 mph ...
Overhaul
1. Remove roof headlining assy
2. Remove sliding roof glass sub–assy
using a torx wrench (t25), remove the 4 screws the sliding roof
glass.
pull the glass upward to remove it.
3. Remove sliding roof weatherstrip
4. Remove sliding roof drive gear sub–assy
Notice:
...