Toyota Corolla (E120): Components
Other materials:
Hydraulic test
1. Perform hydraulic test
Measure the line pressure.
Notice:
Do the test at normal operation atf temperature 50 to 80 °c (122 to
176 °f).
The line pressure test should always be carried out in pairs. One
technician should observe
the conditions of wheels or wheel stopper outsi ...
Body panel undercoating areas
Apply pastar uwe or pastar uc to the chassis, floor underside, sheet metal
fitting weld points of the body, and
inside of the wheel house to prevent rust and noise, as well as protect the body
from flying rocks.
Hint:
work must be performed while wearing the appropriate protective ...
Inspection procedure
1 Inspect ecm(+b voltage)
Turn the ignition switch on.
measure the voltage between the terminals of the e4 and
e6 ecm connectors.
Standard:
2 Check harness and connector(ecm – body ground)
Disconnect the e4 ecm connector.
check the resistance between the wire ...