Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Cruise control system / Problem symptoms table
Toyota Corolla (E120): Problem symptoms table
If a normal code is displayed during the dtc check but the problem still occurs, check the circuits for each problem, symptom in the order given in the table below and proceed to the relevant troubleshooting page.

Other materials:
Inspection procedure
Hint:
start the inspection from step 1 in case of using the hand–held tester and start
from step 2 in case of not
using the hand–held tester.
1 Read value of hand–held tester(skid control sensor)
Check that there is no difference between the speed value output from
the speed sensor ...
On–vehicle inspection
1. Connect hand–held tester:
connect the hand–held tester to the dlc3.
start the engine and run it at idle.
select the active test mode on the hand–held tester.
Hint:
please refer to the hand–held tester operator’s manual for further details.
2. Inspect actua ...
On–vehicle inspection
Notice:
”cold” and ”hot” in these sentences express the temperature of the coils
themselves. ”Cold” is from
–10 c (14 f) to 50 c (122 f) and ”hot” is from 50 c (122 f) to 100 c (212 f).
1. Inspect ignition coil (with igniter) and spark test
confirm dtc.
Notice:
...


