Toyota Corolla (E120): Actuator motor circuit

Dtc 11 actuator motor circuit

Dtc 15 actuator motor circuit

Share this page:

Other materials:

Inspection procedure
1 Check wire harness(dlc3 – airbag sensor assy center) Turn the ignition switch to the lock position.  disconnect the aribag sensor assy center connector.  measure the resistance according to the value(s) in the table below. Standard: 2 Check wire harness(cg of dl ...

Power outlet
The power outlet can be used for 12 V accessories that run on less than 10 A. Lift the lid while pulling up the knob and open the power outlet lid. ■The power outlet can be used when The engine switch is in ACC or ON. ■When turning the engine switch off Disconnect electrical devices with charg ...

Inspection procedure
1 Check p/t squib(lh) circuit(airbag sensor assy center – front seat outer belt assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensio ...