Toyota Corolla (E120): Precaution
- Basic repair hint
- For vehicles equipped with srs airbag and seat belt pretensioner
- Electronic control
- Removal and installation of fuel control parts
- Removal and installation of engine intake parts
- Handling of hose clamps
- For vehicles equipped with mobile communication system
- For vehicles equipped with catalytic converter
Other materials:
On–vehicle inspection
1. Inspect pressure switch no.1.
Magnetic clutch control:
inspect pressure switch operation.
Set on the manifold gauge set.
Connect the positive (+) lead from the ohmmeter to
terminal 4 and the negative (–) lead to terminal 1.
Check continuity between termin ...
Oxygen / af sensor heater monitor
Preconditions
The monitor will not run unless:
mil is off
drive pattern
connect the obd ii scan tool to the dlc3 to check monitor status
and preconditions.
Start the engine and allow it to idle for 9 minutes.
Drive the vehicle at 25 mph (40 km ...
Replacement
1. Drain brake fluid
Notice:
wash the brake fluid off immediately if it comes into contact with any painted
surface.
2. Remove front wheel rh
3. Remove front fender liner rh
4. Remove brake actuator with bracket
turn the latch of the actuator connector to disconnect the
connector. ...