Toyota Corolla (E120) 2002–2008 Repair Manual / Introduction
Toyota Corolla (E120): Introduction
- How to use this manual
- Identification information
- Repair instruction
- How to troubleshoot ecu controlled systems
- General information
- How to proceed with troubleshooting
- Customer problem analysis
- Symptom confirmation and diagnostic trouble code
- Symptom simulation
- Diagnostic trouble code chart
- Problem symptoms table
- Circuit inspection
- Electronic circuit inspection procedure
- Terms
Other materials:
Inspection procedure
Hint:
hand–held tester only:
narrowing down the trouble area is possible by performing ”a/f control” active
test (heated oxygen
sensor or other trouble areas can be distinguished).
Perform active test using hand–held tester (a/f control).
Hint:
”a/f control” is the active te ...
Inspection procedure
1 Inspect skid control ecu connector(+bs terminal voltage)
Disconnect the skid control ecu connector.
measure the voltage between terminals +bs (2) and gnd
(1, 23) of skid control ecu harness side connector.
Voltage: 10 – 14 v
2 Reconfirm dtc
Check the dtc .
Ok :
...
Engine immobilizer system
The vehicle’s keys have built-in transponder chips that prevent the engine
from starting if a key has not been previously registered in the vehicle’s on-board
computer.
Never leave the keys inside the vehicle when you leave the vehicle.
Vehicles without a smart key system: The indicator li ...


