Toyota Corolla (E120): O/d main switch circuit

Share this page:

Other materials:

Basic inspection
When the malfunction is not confirmed in the dtc check, troubleshooting should be carried out in all the possible circuits considered as causes of the problem. In many cases, by carrying out the basic engine check shown in the following flowchart, the location causing the problem can be found ...

Inspection procedure
1 Inspect stop lamp switch assy 2 Check harness and connector(stop lamp switch assy – ecm)   Install the stop lamp switch assy.  disconnect the ecm connector.  measure the voltage according to the value(s) in the table below when the brake pedal is depressed and rele ...

Removal and installation of engine intake parts
If any metal tip is mixed in the inlet pass, this may give a bad effect to the engine and turbocharger.  when removing and installing the inlet system parts, close the opening of the removed inlet system parts and the engine with a clean shop rag or gummed tape.  when inst ...