Toyota Corolla (E120): Malfunction in abs ecu

Dtc alwayson malfunction in abs ecu

Share this page:

Other materials:

Skid control sensor
Replacement Hint: replace the rh side by the same procedure as the lh side. 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Disconnect skid control sensor wire Disconnect the skid control sensor wire connector from the skid control sensor. 4. Remove rear axle hub & ...

Seat belt warning lamp for driver’s seat does not operate
Wiring diagram Inspection procedure 1 Check combination meter assy Ground terminal c9–12 on the combination meter side. check that the warning lightlights up. Ok: warning light lights up. 2 Inspect front seat inner belt assy lh Disconnect the front seat inner belt ...

Inspection procedure
1 Check side squib(rh) circuit(airbag sensor assy center – front seat airbag assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat airbag assy ...