Toyota Corolla (E170): Locking and unlocking the doors

Use the mechanical key  in order to perform the following operations:

1 Locks all the doors 2 Unlocks the door

Turning the key rearward unlocks the driver’s door. Turning the key once again within 5 seconds unlocks the other doors.

Starting the engine

    Share this page:

    Other materials:

    Positioning a floor jack
    When using a floor jack, follow the instructions in the manual provided with the jack and perform the operation safely. When raising your vehicle with a floor jack, position the jack correctly. Improper placement may damage your vehicle or cause injury. Location of the jack point ■ Front ■ Rea ...

    Inspection procedure
    1 Inspect dlc3 terminal voltage Turn the ignition switch to on.  measure voltage between terminals 13 (tc) and 4 (cg) of dlc3. Ok: voltage: 10 – 16 v 2 Check harness and connector(between cruise control ecu assy and dlc3) Check for open and short circuit in harness ...

    Problem symptoms table
    Hint: if a normal code is displayed during the dtc check but the trouble still occurs, check the circuits for each symptom in the order given in the charts on the following pages and proceed to the page given for troubleshooting. The matrix chart is divided into 3 chapters. If the instruc ...