Toyota Corolla (E120): Light control switch circuit

Wiring diagram

Inspection procedure

Inspection procedure

1 Check headlamp dimmer switch assy (light control switch)

2 Check wire harness (tvip ecu  light control switch)

2 Check wire harness (tvip ecu  light control switch)

  1. Disconnect the tvip ecu and light control switch connectors.
  2.  check the continuity between the terminals of the tvip ecu and light control switch connectors, as shown in the illustration and table.

Standard:

3 Check wire harness (light control switch  body ground)

3 Check wire harness (light control switch  body ground)

  1. Disconnect the light control switch connector.
  2. check the continuity between the terminal of the light control switch connector and the body ground, as shown in the illustration and table.

Standard:

Proceed to next circuit inspection shown on problem symptoms table

Proceed to next circuit inspection shown on problem symptoms table

    Share this page:

    Other materials:

    Inspection procedure
    1 Check airbag sensor assy center connector Disconnect negative (–) terminal cable from the battery, and wait at least for 90 seconds.  check the connection of the airbag sensor assy center connectors. 2 Check air bag sensor assy center Sst 09843–18040 Connect the n ...

    Heated steering wheel/seat heaters
    Heated steering wheel Warms up the grip of the steering wheel Seat heaters Warm up the seat upholstery WARNING To prevent minor burn injuries Care should be taken if anyone in the following categories comes in contact with the steering wheel or seats when the heater is on: Babies, small chil ...

    LTA (Lane Tracing Assist)
    LTA functions When driving on a road with clear lane lines with the dynamic radar cruise control operating, lane lines and preceding and surrounding vehicles are detected using the front camera and radar sensor, and the steering wheel is operated to maintain the vehicle's lane position. ...