Toyota Corolla (E120): Exterior/interior trim

Preparation

Recomended tools

Equipment

Equipment

Vehicle control system

Vehicle control system

Preparation

Recomended tools

Cruise control

    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect dlc3 terminal voltage Turn the ignition switch to on.  measure voltage between terminals 13 (tc) and 4 (cg) of dlc3. Ok: voltage: 10 – 16 v 2 Check harness and connector(between cruise control ecu assy and dlc3) Check for open and short circuit in harness ...

    Circuit description
    Refer to dtcs p0100 Dtc no. Dtc detection condition Trouble area P0101 After engine is warmed up, conditions (a) to (d) continue for more than 10 seconds (2 trip detection logic):  engine speed less than 900 rpm  throttle valve fully closed &nbs ...

    Adjusting the mirrors
    Make sure that you can see backward clearly by adjusting the inside and outside rear view mirrors properly. CAUTION Observe the following precautions. Failure to do so may result in death or serious injury. ●Do not adjust the position of the driver’s seat while driving. Doing so could ...