Toyota Corolla (E120): Cruise control

Preparation

Sst

Recomended tools

Recomended tools

Equipment

Equipment

Service specifications

    Share this page:

    Other materials:

    Inspection procedure
    Hint: when the throttle position is slightly opened (the accelerator pedal is slightly depressed) because a floor carpet is overlapped on the accelerator pedal, or if not fully releasing the accelerator pedal, etc., Dtc p505 will possibly be detected. Read freeze frame data using the ...

    Inspection procedure
    1 Inspect dlc3 terminal voltage(tc terminal) Turn the ignition switch to on.  measure voltage between terminals tc and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector betw ...

    Body
    On–vehicle inspection 1. Canada: tighten bolts and nuts on chassis and body  tighten the bolts and nuts on the chassis parts listed below, if necessary Front axle and suspension drive train rear axle and suspension brake system engine mounting other chassis parts ...