Toyota Corolla (E120): Inspection procedure

1 Inspect dlc3 terminal voltage(tc terminal)

  1. Turn the ignition switch to on.
  2.  measure voltage between terminals tc and cg of dlc3.

    Ok: voltage: 10 – 14 v

2 Check harness and connector(dlc3 – body ground)

2 Check harness and connector(dlc3 – body ground)

  1. Check for open and short circuit in harness and connector between terminal cg of the dlc3 and body ground

3 Check harness and connector(skid control ecu – dlc3)

3 Check harness and connector(skid control ecu – dlc3)

  1. Check for open and short circuit in harness and connector between terminal tc of the skid control ecu and dlc3

Check and replace brake actuator assy

Check and replace brake actuator assy

    Share this page:

    Other materials:

    Listening to an iPod
    Connecting an iPod enables you to enjoy music from the vehicle speakers. Select “iPod” on the audio source selection screen. When the iPod connected to the system includes iPod video, the system can only output the sound by selecting the browse screen. Connecting an iPod Audio control scre ...

    Warning buzzer does not sound (key reminder warning, light reminder warning)
    Wiring diagram Inspection procedere 1 Check buzzer Check that all of the warning buzzers sound. 2 Inspect front door courtesy lamp switch assy 3 Inspect un–lock warning switch assy 4 Check harness and connector(between un–lock warning switch and combination meter as ...

    Continuously variable transmission (vehicles without paddle shift switches)
    Select the shift position depending on your purpose and situation. Shift position purpose and functions P - Parking the vehicle/ starting the engine R - Reversing N - Neutral (Condition in which the power is not transmitted) D - Normal driving* B - Applying moderate engine braking driving down hills ...