Toyota Corolla (E120): Circuit description

Connecting terminals tc and cg of the dlc3 causes the ecu to display the dtc by flashing the abs warning light.

Wiring diagram

Inspection procedure

    Share this page:

    Other materials:

    Inspection procedure
    1 Reconfirm dtc Check the dtc 2 Inspect skid control ecu connector securely connected 3 Inspect skid control ecu connector(ig1 terminal voltage) In case of using hand–held tester:  check the voltage condition output from the ecu displayed on the hand–held tester. O ...

    Replacement
    Hint: installation is in the reverse order of the removal. But the installation is indicated only when it has a point. 1. Remove spare wheel cover assy 2. Remove rear floor finish plate Remove the 3 clips.  using a moulding remover, remove the rear floor finish plate. 3. Rem ...

    Do-it-yourself service precautions
    If you perform maintenance by yourself, be sure to follow the correct procedure as given in these sections. Maintenance WARNING The engine compartment contains many mechanisms and fluids that may move suddenly, become hot, or become electrically energized. To avoid death or serious injury, obser ...