Toyota Corolla (E120): Components

Overhaul

    Share this page:

    Other materials:

    Electronic control
    Removal and installation of battery terminal  before performing electrical work, disconnect the battery negative (–) terminal cable beforehand so as to prevent burnt–out damage by short.  When disconnecting and installing the terminal cable, turn the ignition switch an ...

    Inspection procedure
    Hint: start the inspection from step 1 in case of using the hand–held tester and start from step 2 in case of not using the hand–held tester. 1 Perform active test by hand–held tester(abs motor relay) Check the operation sound of the abs motor individually when operaing it with the ...

    Inspection procedure
    1 Inspect shift solenoid valve(s1) Remove the shift solenoid valve s1. measure the resistance according to the value(s) in the table below. Standard: Connect the positive (+) battery lead to the solenoid connector terminal, and the negative (–) battery lead to the solenoid ...