Toyota Corolla (E120): Generator assy

On–vehicle inspection

Replacement

Other materials:

Evap monitor (vacuum pressure monitor)
Notice: a cold soak must be performed prior to conducting the drive pattern to complete the internal pressure readiness monitor. Cold soak preconditions The monitor will not run unless: mil is off. Fuel level is approximately 1/2 to 3/4. Altitude is 7800 feet (2400 m) or less. ...

Inspection procedure
Hint: hand–held tester only: narrowing down the trouble area is possible by performing ”a/f control” active test (heated oxygen sensor or other trouble areas can be distinguished).  perform active test using hand–held tester (a/f control). Hint: ”a/f control” is the act ...

Replacement
Hint: components: 1. Precaution 2. Disconnect battery negative terminal 3. Remove seat track upper rail cover rh 4. Remove seat track upper rail cover lh 5. Remove front seat assy lh 6. Remove seat position air bag sensor Disconnect the connector of the seat position airbag sensor. ...