Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Cruise control system / Clutch switch circuit / Circuit description
Toyota Corolla (E120): Circuit description
When the clutch pedal is depressed, the clutch switch sends a signal to the cruise control ecu assy. When the signal is input to the cruise control ecu assy during cruise control driving, the cruise control ecu assy cancels the cruise control.
Wiring diagram

Other materials:
Inspection procedure
Hint:
start the inspection from step 1 in case of using the hand–held tester and start
from step 2 in case of not
using the hand–held tester.
1 Perform active test by hand–held tester(abs warning light)
Check that ”on” and ”off” of the abs warning light can be shown on the
...
For vehicles equipped with catalytic converter
Caution:
if large amount of unburned fuel flows into the converter, it may cause
overheating and a fire hazard.
To prevent this, observe the following precautions.
Use only unleaded gasoline.
avoid prolonged idling.
Avoid running the engine at idle speed for more than 20 minutes. ...
Skid control sensor
Replacement
Hint:
replace the rh side by the same procedure as the lh side.
1. Remove rear wheel
2. Remove rear brake drum sub–assy
3. Disconnect skid control sensor wire
Disconnect the skid control sensor wire connector from
the skid control sensor.
4. Remove rear axle hub & ...


