Toyota Corolla (E120): Windshield glass

Share this page:

Other materials:

Dtc check/clear
1. Dtc check (normal mode) Notice: hand–held tester only: when the diagnostic system is switched from the normal mode to the check mode, all the dtcs and freeze frame data recorded in the normal mode will be erased. So before switching modes, always check the dtcs and freeze frame data, and ...

Inspection procedure


Hand–held tester: 1 Check operation of stop light Check if the stop lights go on and off normally when the brake pedal is depressed and released. 2 Inspect stop light switch assy Check the resistance between the terminals when the switch is turned on and off. Standard: ...

Inspection procedure
1 Check side squib(rh) circuit(airbag sensor assy center – front seat airbag assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds. disconnect the connectors between the front seat airbag assy (rh) and the airbag sensor assy center. ...