Toyota Corolla (E120): Vehicle control system

Ignition or starter switch assy

Replacement

1. Remove steering column cover

2. Remove ignition or starter switch assy

  1. Disconnect the ignition switch connector and unlock warning switch connector.
  2.  remove the 2 clamps.
  3.  remove the 2 screws and ignition switch.

Inspection

1. Inspect ignition or starter switch assy

  1. Inspect the ignition switch.

Standard:

If the continuity is not as specified, replace the switch.

If the continuity is not as specified, replace the switch.

    Share this page:

    Other materials:

    On–vehicle inspection
    1. Check battery electrolyte level Check the electrolyte quantity of each cell (maintenance–free battery).  If under the lower level, replace the battery (or add distilled water if possible) and check the charging system.  check the electrolyte quantity of each cell ...

    Replacement
    Hint: components: 1. Precaution 2. Disconnect battery negative terminal 3. Remove front door scuff plate rh 4. Remove rear door scuff plate rh 5. Remove front door opening trim rh 6. Remove rear door opening trim rh 7. Remove lap belt outer anchor cover 8. Remove center pillar garnis ...

    Registering ID codes (vehicles with a tire pressure warning system)
    The tire pressure warning valve and transmitter is equipped with a unique ID code. When new tire pressure warning valves and transmitters are installed, new ID codes must be registered in the tire pressure warning computer. ID codes can be registered by yourself, but depending on the driving con ...