Toyota Corolla (E170): Using a flat bed truck

If you use chains or cables to tie down your vehicle, the angles shaded in black must be 45°.

Do not overly tighten the tie downs or the vehicle may be damaged.

■Before emergency towing

■Before emergency towing

1 Vehicles without a smart key system: Put the engine switch in the “ACC” (engine off) or “ON” position (engine running).

Vehicles with a smart key system: Put the engine switch in ACCESSORY (engine off) or IGNITION ON (engine running) mode.

2 Shift the shift lever to N.

3 Release the parking brake.

CAUTION

Observe the following precautions.

Failure to do so may result in death or serious injury.

■Caution while towing

●Use extreme caution when towing the vehicle.

Avoid sudden starts or erratic driving maneuvers which place excessive stress on the emergency towing eyelet and the cables or chains. Always be cautious of the surroundings and other vehicles while towing.

●If the engine is not running, the power assist for the brakes and steering will not function, making steering and braking more difficult.

NOTICE

■To prevent causing serious damage to the transmission when towing using a wheel-lift type truck

Never tow this vehicle from the rear with the front wheels on the ground.

■To prevent damage to the vehicle when towing using a wheel-lift type truck (except vehicles with a manual transmission)

When raising the vehicle, ensure adequate ground clearance for towing at the opposite end of the raised vehicle. Without adequate clearance, the vehicle could be damaged while being towed from the rear.

■To prevent damage to the vehicle when towing using a wheel-lift type truck (vehicles with a manual transmission)

●Vehicles without a smart key system: Do not tow the vehicle from the rear when the engine switch is in the “LOCK” position or the key is removed.

The steering lock mechanism is not strong enough to hold the front wheels straight.

●Vehicles with a smart key system: Do not tow the vehicle from the rear when the engine switch is off. The steering lock mechanism is not strong enough to hold the front wheels straight.

●When raising the vehicle, ensure adequate ground clearance for towing at the opposite end of the raised vehicle. Without adequate clearance, the vehicle could be damaged while being towed.

■To prevent body damage when towing with a sling-type truck

Do not tow with a sling-type truck, either from the front or rear.

■To prevent causing serious damage to the transmission in emergency towing

Never tow a vehicle from the rear with four wheels on the ground. This may cause serious damage to the transmission.

    Share this page:

    Other materials:

    Circuit description
    The ignition switch provides circuit power and the ecm provides the circuit ground that illuminates the mil. Mil operation is checked visually: it should be illuminated when the ignition is first turned on. If the mil is off all of the time or on all of the time, use the procedure below to ...

    Removal & installation and disassembly & re
    1. Remove bench type rear seat cushion assy (, 72–8) 2. Remove rear floor service hole cover 3. Work for preventing gasoline from spilling out  start the engine.  after the engine has stopped on the its own, turn the ignition switch to lock. 4. Disconnect fuel tank main tu ...

    Fuel information
    You must only use unleaded gasoline in your vehicle. Select octane rating 87 (Research Octane Number 91) or higher. Use of unleaded gasoline with an octane rating lower than 87 may result in engine knocking. Persistent knocking can lead to engine damage. At minimum, the gasoline you use should ...