Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Sfi system / Throttle/pedal position sensor/switch ”a” circuit

Toyota Corolla (E120): Throttle/pedal position sensor/switch ”a” circuit

Dtc p0120 throttle/pedal position sensor/switch ”a” circuit

Dtc p0122 throttle/pedal position sensor/switch ”a” circuit low input

Dtc p0123 throttle/pedal position sensor/switch ”a” circuit high input

Hint

: this is the purpose for the ”throttle position sensor”.

Share this page:

Other materials:

Seat belt warning lamp for front passenger’s seat does not flash
Wiring diagram Inspection procedure 1 Inspect combination meter assy Ground terminal c9–11 on the combination meter side.  check that the warning lightlights up. Ok: warning light lights up. 2 Inspect passenger seat belt warning lamp assy Ground terminal c9– ...

Evap monitor (vacuum pressure monitor)
Notice: a cold soak must be performed prior to conducting the drive pattern to complete the internal pressure readiness monitor. Cold soak preconditions The monitor will not run unless: mil is off. Fuel level is approximately 1/2 to 3/4. Altitude is 7800 feet (2400 m) or less. ...

Engine rear oil seal
Replacement 1. Remove manual transaxle assy (m/t transaxle) 2. Remove automatic transaxle assy (a/t transaxle) 3. Remove clutch cover assy (m/t transaxle)  remove the 6 bolts and clutch cover. 4. Remove clutch disc assy (m/t transaxle) 5. Remove flywheel sub–assy (m/t transaxle ...