Toyota Corolla (E210): Switches
- Instrument panel light control dial
- Automatic High Beam switch
- Heated steering wheel switch*
- Windshield wiper de-icer switch*
- Outside rear view mirror switch
- Door lock switches
- Power window switches
- Window lock switch
*: If equipped
- Meter control switches
- Paddle shift switches*1
- Cruise control switches Dynamic radar cruise control Cruise control
- Audio remote control switches*2
- LTA (Lane Tracing Assist) switch
- Phone switch*2
- Talk switch*2
*1:If equipped
*2:Refer to "MULTIMEDIA OWNER'S MANUAL".
- Seat heater switches*
- Wireless charger switch*
- Brake hold switch
- Parking brake switch Applying/releasing Precautions against winter season Warning buzzer/message
- VSC OFF switch
- Driving mode select switch*
*: If equipped
Other materials:
Inspection procedure
Hint:
if different dtcs related to different systems that have terminal e2
as the ground terminal are output
simultaneously, terminal e2 may be open.
Read freeze frame data using the hand-held tester or the obd ii scan
tool. Freeze frame data records
the engine conditions when a malf ...
Inspection
1. Spark plug
Notice:
never use a wire brush for cleaning.
Never attempt to adjust the electrode gap on used
spark plug.
Spark plug should be replaced every 192,000 km
(120,000 miles).
Clean the spark plugs.
Air pressure: below 588 kpa (6.0 Kg/cm2, 85 psi)
duration: 20 sec ...
On–vehicle inspection
1. Inspect drive belt
Visually check the belt for excessive wear, frayed cords,
etc.
If any defect is found, replace the drive belt.
Hint:
cracks on the rib side of a belt are considered acceptable. If the
missing chunks from the ribs are found on the belt, it should be
replaced.
2 ...