Toyota Corolla (E210): Pictorial index

Share this page:

Other materials:

Inspection procedure
1 Inspect stop lamp switch assy 2 Check harness and connector(stop lamp switch assy – ecm)   Install the stop lamp switch assy.  disconnect the ecm connector.  measure the voltage according to the value(s) in the table below when the brake pedal is depressed and rele ...

Inspection procedure
1 Inspect skid control ecu connector(+bs terminal voltage) Disconnect the skid control ecu connector.  measure the voltage between terminals +bs (2) and gnd (1, 23) of skid control ecu harness side connector. Voltage: 10 – 14 v 2 Reconfirm dtc Check the dtc . Ok : ...

Confirmation driving pattern
Connect the hand–held tester or the obd ii scan tool to the dlc3.  record dtcs and the freeze frame data.  set the check mode using the hand–held tester .  read the value on the misfire counter for each cylinder when idling. If the value is displayed on the misfire c ...