Toyota Corolla (E170): Steering wheel

Share this page:

Other materials:

Light control switch circuit
Wiring diagram Inspection procedure 1 Check headlamp dimmer switch assy (light control switch) 2 Check wire harness (tvip ecu  light control switch) Disconnect the tvip ecu and light control switch connectors.  check the continuity between the terminals of the tvip e ...

On–vehicle inspection
1. Inspect drive belt Visually check the belt for excessive wear, frayed cords, etc. If any defect is found, replace the drive belt. Hint: cracks on the rib side of a belt are considered acceptable. If the missing chunks from the ribs are found on the belt, it should be replaced. 2 ...

Diagnostic trouble code chart
The inspection procedures are shown in the table below. This table allows efficient and accurate troubleshooting using the diagnostic trouble codes displayed in the diagnostic trouble code chart. Proceed with troubleshooting in accordance with the inspection procedures listed in the diagnost ...