Toyota Corolla (E120): Speed control main switch assy

Replacement

1. Disconnect battery negative terminal

2. Inspect place front wheels facing straight ahead

3. Remove horn button assy

4. Remove steering wheel assy

sst 09950–50013 (09951–05010, 09952–05010, 09953–05020, 09954–05021)

5. Remove speed control main switch assy

  1. Remove the 2 screws and cruise control main switch assy.

6. Center spiral cable

7. Install steering wheel assy

8. Inspect steering wheel center point

9. Inspect horn button assy

10. Install horn button assy

11. Inspect srs warning light

    Share this page:

    Other materials:

    Inspection
    1. Charcoal canister assy Visually check the charcoal canister for cracks or damage. Inspect the charcoal canister operation.  Plug the vent port with the cap.  While holding the purge port closed, blow air (1.76 Kpa, 18 gf/cm2, 0.26 Psi) into the evap port and ...

    Inspection procedure
    Hint: hand–held tester only: narrowing down the trouble area is possible by performing ”a/f control” active test (heated oxygen sensor or other trouble areas can be distinguished). Perform active test using hand–held tester (a/f control). Perform active test using the hand–held ...

    Front suspension
    Service data *1: Ground clearance of front wheel center *2: ground clearance of lower suspension arm front bolt center *3: ground clearance of axle beam set bolt center *4: ground clearance of rear wheel center Torque specification ...