Toyota Corolla (E210): Specifications

Share this page:

Other materials:

Inspection procedure
1 Check source voltage Measure the voltage of the battery. Ok: voltage: 10 – 14 v 2 Check air bag sensor assy center Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors from the airbag sensor assy ...

Overhaul
1. Remove cylinder block water drain cock sub–assy Remove the cylinder block water drain cock from the cylinder block. 2. Inspect connecting rod thrust clearance Using a dial indicator, measure the thrust clearance while moving the connecting rod back and forth. Standard t ...

Oxygen / af sensor heater monitor
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...