Toyota Corolla (E170): Setting call volume

1 Select “Call volume” using Change the call volume.. 2 Change the call volume.

To decrease the volume: Turn To increase the volume: Turn  clockwise. counterclockwise.

To increase the volume: Turn Setting ringtone volume clockwise.

    Share this page:

    Other materials:

    Adjustment
    Hint: in the rh side, work in the same procedure as in the lh side. Since the centering bolt is used as a door side hinge bolt, the door hinge cannot be adjusted with it on. Substitute the bolt with washer for the centering bolt. 1. Inspect front door panel sub–assy lh Che ...

    Oxygen / af sensor heater monitor
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

    Inspection procedure
    1 Inspect transmission wire(slt) Disconnect the transmission wire connector from the transaxle. measure the resistance according to the value(s) in the table below. Standard: Measure the resistance according to the value(s) in the table below. Standard (check for short): ...