Toyota Corolla (E120): Replacement

1. Remove radiator grille sub–assy

2. Remove front bumper cover

3. Remove fog lamp assy lh

  1. Remove a nut and release a claw.
  2.  remove the fog light assy lh.

4. Put vehicle these conditions

5. Adjust fog light aim

6. Check fog light aim

    Share this page:

    Other materials:

    Circuit description
    The throttle position sensor is mounted in the throttle body and detects the throttle valve opening angle. When the throttle valve is fully closed, a voltage of approximately 0.3 To 1.0 V is applied to terminal vta of the ecm. The voltage applied to terminal vta of the ecm increases in pro ...

    Replacement
    1. Remove combination meter assembly 2. Disconnect brake master cylinder push rod clevis  remove the clip and push rod clevis pin and wave washer, and disconnect the push rod clevis from the brake pedal. 3. Remove brake pedal support sub–assy Remove the bolt from the bra ...

    Inspection procedure
    1 Inspect dlc3 terminal voltage(tc terminal) Turn the ignition switch to on.  measure voltage between terminals tc and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector betw ...