Toyota Corolla (E120): Adjustment
1. Put vehicle these conditions
- tire inflation pressure is the specified value .
- start the engine.
2. Adjust fog light aim

- The fog light aim can be adjusting by moving the aiming screw in the vertical direction.
Hint
: the optical aim moves upward when turning a screwdriver clockwise, while it moves downward when turning a screwdriver counterclockwise.
3. Check fog light aim
Other materials:
Inspection procedure
1 Check side squib(lh) circuit(airbag sensor assy center – front
seat airbag assy lh)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the airbag sensor
assy center and the front seat airbag assy ...
Speed sensor front lh
Replacement
Hint:
replace the rh side by the same procedure as the lh side.
1. Remove front wheel
2. Remove front fender liner lh
3. Remove speed sensor front lh
Disconnect the speed sensor wire harness clamp from
the body.
disconnect the speed sensor connector.
Remo ...
Inspection procedure
1 Inspect terminal voltage(od – body ground)
Disconnect the cruise control ecu connector.
turn the ignition switch to the on position.
measure the voltage between terminal od of cruise control
ecu and body ground.
Standard:
2 Inspect terminal voltage(od1 – bod ...


