Toyota Corolla (E120): Rear suspension

Service data

Torque specification

Torque specification

Tire&wheel

Tire&whee

l

Service data

Drive shaft / propeller shaft / axle

Drive shaft / propeller shaft / axle

Service data

Torque specification

Torque specification

Brake

    Share this page:

    Other materials:

    Inspection procedure
    1 Check security indicator light Remove the security indicator.  check the indicator light, as shown in the illustration and table. Standard: 2 Check wire harness (tvip ecu  security indicator) Disconnect the tvip ecu and security indicator connectors.   ...

    Temporarily engaged gear steps selection mode in the D position
    To drive in temporary gear steps selection mode, operate the “-” and “+” paddle shift switches. The gear steps can then be selected by operating the “-” and “+” paddle shift switches. By selecting gear step using paddle shift switches, you can control engine braking forces. 1 ...

    Inspection procedure
    Hint: when the throttle position is slightly opened (the accelerator pedal is slightly depressed) because a floor carpet is overlapped on the accelerator pedal, or if not fully releasing the accelerator pedal, etc., Dtc p505 will possibly be detected. Read freeze frame data using the ...