Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Toyota vehicle intrusion protection system / Problem symptoms table
Toyota Corolla (E120): Problem symptoms table
Proceed to the reference page shown in the table below for each malfunction symptom and troubleshoot each circuit.
Hint
: troubleshooting of the tvip system is based on the premise that the door lock control system and wireless door lock control system is operating normally. Accordingly, before troubleshooting the tvip system, first make certain that the door lock control system and wireless door lock control system is operating normally.

Other materials:
Circuit description
The variable valve timing (vvt) system includes the ecm, the oil control
valve (ocv) and the vvt controller.
The ecm sends a target ”duty–cycle” control signal to the ocv. This control
signal, applied to the ocv,
regulates the oil pressure supplied to the vvt controller. Camshaft timin ...
Inspection procedure
Hand–held tester:
1 Perform active test by hand–held tester(operation of circuit
opening relay)
Connect the hand–held tester to the dlc3.
turn the ignition switch on and push the hand–held tester main
switch on.
select the item ”diagnosis / enhanced obd ii / active ...
Inspection
1. Spark plug
Notice:
never use a wire brush for cleaning.
Never attempt to adjust the electrode gap on used
spark plug.
Spark plug should be replaced every 192,000 km
(120,000 miles).
Clean the spark plugs.
Air pressure: below 588 kpa (6.0 Kg/cm2, 85 psi)
duration: 20 sec ...


