Toyota Corolla (E170): Power windows

Share this page:

Other materials:

Inspection
1. Cooling fan relay Inspect the cooling fan relay continuity.  Using an ohmmeter, check that there is continuity between terminals 1 and 2. If there is no continuity, replace the relay.  Check that there is no continuity between terminals 3 and 5. If there is conti ...

Inspection procedure
1 Check wire harness(dlc3 – airbag sensor assy center) Turn the ignition switch to the lock position.  disconnect the aribag sensor assy center connector.  measure the resistance according to the value(s) in the table below. Standard: 2 Check wire harness(cg of dl ...

Replacement
1. Remove instrument panel sub–assy lower 2. Remove clutch pedal spring 3. Remove clutch master cylinder push rod clevis w/hole pin Remove the clip and hole pin. 4. Remove clutch pedal support sub–assy W/ cruise control: disconnect the clutch switch assy connector. &nbs ...