Toyota Corolla (E120): Open in p squib (2nd step) circuit

Dtc b1186/58 open in p squib (2nd step) circuit

Share this page:

Other materials:

Inspection procedure
1 Inspect ecm(+b voltage) Turn the ignition switch on.  measure the voltage between the terminals of the e4 and e6 ecm connectors. Standard: 2 Check harness and connector(ecm – body ground) Disconnect the e4 ecm connector. check the resistance between the wire ...

Inspection procedure
1 Check p/t squib(lh) circuit(airbag sensor assy center – front seat outer belt assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensio ...

Inspection procedure
1 Inspect shift solenoid valve(sl) Remove the shift solenoid valve sl.  measure the resistance according to the value(s) in the table below. Standard: Connect the positive (+) battery lead to the solenoid connector terminal, and the negative (–) battery lead to the so ...