Toyota Corolla (E170): Moon roof
Use the overhead switches to open and close the moon roof and tilt it up and down.
■ Opening and closing
1 Opens the moon roof* The moon roof stops slightly before the fully open position to reduce wind noise.
Press the switch again to fully open the moon roof.
2 Closes the moon roof*
*: Lightly press the switch in either direction to stop the moon roof partway.
■ Tilt up and down
1 Tilts the moon roof up* 2 Tilts the moon roof down*
*: Lightly press either of the moon roof switches to stop the moon roof partway.
■The moon roof can be operated when
► Vehicles without a smart key system The engine switch is in the “ON” position.
► Vehicles with a smart key system The engine switch is in IGNITION ON mode.
■Operating the moon roof after turning the engine off
► Vehicles without a smart key system The moon roof can be operated for approximately 45 seconds after the engine switch is turned to the “ACC” or “LOCK” position. It cannot, however, be operated once either front door is opened.
►Vehicles with a smart key system The moon roof can be operated for approximately 45 seconds after the engine switch is turned to ACCESSORY mode or turned off. It cannot, however, be operated once either front door is opened.
■Jam protection function
If an object is detected between the moon roof and the frame while the moon roof is closing or tilting down, travel is stopped and the moon roof opens slightly.
■Sunshade
The sunshade can be opened and closed manually. However, the sunshade will open automatically when the moon roof is opened.
■When the moon roof does not close normally
Perform the following procedure:
●If the moon roof closes but then re-opens slightly
1 Stop the vehicle.
2 Press and hold the “CLOSE” switch.*1 The moon roof will close, reopen and pause for approximately 10 seconds.* 2 Then it will close again, tilt up and pause for approximately 1 second.
Finally, it will tilt down, open and close.
3 Check to make sure that the moon roof is completely closed and then release the switch.
●If the moon roof tilts down but then tilts back up
1 Stop the vehicle.
2 Press and hold the “UP” switch*1 until the moon roof moves into the tilt up position and stops.
3 Release the “UP” switch once and then press and hold the “UP” switch again.*1 The moon roof will pause for approximately 10 seconds in the tilt up position.* 2 Then it will adjust slightly and pause for approximately 1 second.
Finally, it will tilt down, open and close.
4 Check to make sure that the moon roof is completely closed and then release the switch.
*1: If the switch is released at the incorrect time, the procedure will have to be performed again from the beginning.
*2: If the switch is released after the above mentioned 10 second pause, automatic operation will be disabled. In that case, press and hold the open/close switch in the close position or press and hold the “UP” switch.
The moon roof will tilt up and pause for approximately 1 second. Then it will tilt down, open and close. Check to make sure that the moon roof is completely closed and then release the switch.
If the moon roof does not fully close even after performing the above procedure correctly, have the vehicle inspected by your Toyota dealer.
■Moon roof open reminder function
An alarm will sound when the driver’s door is opened with the moon roof not fully closed and the engine switch off.
CAUTION
■Opening the moon roof
Observe the following precautions.
Failure to do so may cause death or serious injury.
●Do not allow any passengers to put their hands or heads outside the vehicle while it is moving.
●Do not sit on top of the moon roof.
■Closing the moon roof
Observe the following precautions.
Failure to do so may result in death or serious injury.
●Check to make sure that all passengers do not have any part of their bodies in a position where they could be caught when the moon roof is being operated.
●Do not allow children to operate the moon roof.
Closing the moon roof on someone can cause death or serious injury.
■Jam protection function
●Never use any part of your body to intentionally activate the jam protection function.
●The jam protection function may not work if something gets caught just before the moon roof fully closes.
Other materials:
Replacement
1. Drain brake fluid
Notice:
wash the brake fluid off immediately if it comes into contact with any painted
surface.
2. Remove front wheel rh
3. Remove front fender liner rh
4. Remove brake actuator with bracket
turn the latch of the actuator connector to disconnect the
connector. ...
Other functions
■ Switching between outside air and recirculated air modes
Press .
The mode switches between outside air mode (indicator off) and recirculated air
mode (indicator on) each time is pressed.
■ Defogging the windshield
Defoggers are used to defog the windshield and front side w ...
Replacement
1. Remove engine under cover rh
2. Remove cylinder head cover no.2
Remove the 2 screw, 3 clips and engine under cover.
3. Remove fan and generator v belt
Turn the v–ribbed belt tensioner slowly clockwise and
loosen it. Then, remove the fan and generator v belt and
put back ...