Toyota Corolla (E120): Inspection procedure

1 Input signal check

  1. See input signal check on page 05–745.
  2. check indicator light operation when driving with vehicle speed above 40 km/h (25 mph), and with vehicle speed below 40 km/h (25 mph).

    Ok: vehicle speed above 40 km/h (25 mph): indicator light blinks vehicle speed below 40 km/h (25 mph): indicator light stays on

2 Check speedometer circuit

2 Check speedometer circuit

3 Check harness and connector(between cruise control ecu assy

3 Check harness and connector(between cruise control ecu assy and combination meter assembly)

  1. Check for open and short circuit in harness and connector between cruise control ecu assy and combination meter assembly

Check and replace cruise control ecu assy

Check and replace cruise control ecu assy

    Share this page:

    Other materials:

    General information
    1. Basic dimensions (a) there are two types of dimensions in the diagram. (1) (Three-dimensional distance) straight-line distance between the centers of two measuring points. (2) (Two-dimensional distance) horizontal distance in forward/rearward direction between the centers o ...

    Inspection procedure
    Hint: start the inspection from step 1 in case of using the hand–held tester and start from step 2 in case of not using the hand–held tester. 1 Read value of hand–held tester(front speed sensor) Select the datalist mode on the hand–held tester.  check that there is no differe ...

    Child restraint systems with a top tether strap
    1 Adjust the head restraint to the downmost position. 2 Secure the child restraint system using the seat belt or LATCH anchors. 3 Open the anchor bracket cover, latch the hook onto the anchor bracket and tighten the top tether strap. Make sure the top tether strap is securely latched. ` ...